SLUS334C − AUGUST 1995 − REVISED AUGUST 2004
www.ti.com
3
TERMINAL FUNCTIONS
TERMINAL
NO. I/O DESCRIPTION
J or DW Q or L
CLK/LEB 4 5 O Output of the internal oscillator
CT 6 8 I
Timing capacitor connection pin for oscillator frequency programming. The timing capacitor should
be connected to the device ground using minimal trace length.
EAOUT 3 4 O Output of the error amplifier for compensation
GND 10 13 − Analog ground return pin
ILIM 9 12 I Input to the current limit comparator
INV 1 2 I Inverting input to the error amplifier
NI 2 3 I Non-inverting input to the error amplifier
OUTA 11 14 O High current totem pole output A of the on-chip drive stage.
OUTB 14 18 O High current totem pole output B of the on-chip drive stage.
PGND 12 15 − Ground return pin for the output driver stage
RAMP 7 9 I
Non-inverting input to the PWM comparator with 1.25-V internal input offset. In voltage mode
operation, this serves as the input voltage feed-forward function by using the CT ramp. In peak
current mode operation, this serves as the slope compensation input.
RT 5 7 I Timing resistor connection pin for oscillator frequency programming
SS 8 10 I Soft-start input pin which also doubles as the maximum duty cycle clamp.
VC 13 17 −
Power supply pin for the output stage. This pin should be bypassed with a 0.1-µF monolithic ceramic
low ESL capacitor with minimal trace lengths.
VCC 15 19 −
Power supply pin for the device. This pin should be bypassed with a 0.1-µF monolithic ceramic low
ESL capacitor with minimal trace lengths
VREF 16 20 O
5.1-V reference. For stability, the reference should be bypassed with a 0.1-µF monolithic ceramic
low ESL capacitor and minimal trace length to the ground plane.
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range unless otherwise noted
(1)
UNIT
V
IN
Supply voltage, VC, VCC 22 V
I
O
Source or sink current, DC OUTA, OUTB 0.5 A
I
O
Source or sink current, pulse (0.5 µs) OUTA, OUTB 2.2 A
INV, NI, RAMP −0.3 V to 7 V
ILIM, SS −0.3 V to 6 V
Power ground PGND ±0.2 V
I
CLK
Clock output current CLK/LEB −5 mA
I
O(EA)
Error amplifier output current EAOUT 5 mA
I
SS
Soft-start sink current SS 20 mA
I
OSC
Oscillator charging current RT −5 mA
T
J
Operating virtual junction temperature range −55°C to 150°C
T
stg
Storage temperature −65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds −55C°C to 150°C
t
STG
Storage temperature −65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from cases for 10 seconds 300°C
(1)
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
