G3SBA20 AND G3SBA60
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
Reverse Voltage - 200 and 600 Volts Forward Current - 4.0 Amperes
FEATURES
¨ Plastic package has Underwriters Laboratory Flammability
Classification 94V-0
¨ This series is UL listed under the Recognized Component
Index, file number E54214
¨ High case dielectric
strength of 1500 V
RMS
¨ Ideal for printed circuit boards
¨ Glass passivated chip junction
¨ High surge current capability
¨ High temperature soldering guaranteed:
260¡C/10 seconds, 0.375 (9.5mm) lead length,
5lbs. (2.3kg) tension
MECHANICAL DATA
Case: Molded plastic body over passivated junctions
Terminals: Plated leads solderable per MIL-STD-750,
Method 2026
Mounting Position: Any
(NOTE 3)
Mounting Torque: 5 in. - lb. max.
Weight: 0.15 ounce, 4.0 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25¡C ambient temperature unless otherwise specified.
SYMBOLS G3SBA20 G3SBA60 UNITS
Maximum repetitive peak reverse voltage V
RRM
200 600 Volts
Maximum RMS voltage V
RMS
140 420 Volts
Maximum DC blocking voltage V
DC
200 600 Volts
Maximum average forward rectified T
C
=100¡C
(NOTE 1)
4.0
output current at T
A
=25¡C
(NOTE 2)
I
(AV)
2.3
Amps
Peak forward surge current single sine-wave
superimposed on rated load (JEDEC Method)
I
FSM
80 Amps
Rating for fusing (t<8.3ms) I
2
t32A
2
sec
Maximum instantaneous forward voltage drop
per leg at 2.0A
V
F
1.05 Volts
Maximum DC reverse current at T
A
=25¡C 5.0
rated DC blocking voltage per leg T
A
=125¡C
I
R
400
mA
Typical thermal resistance per leg
(NOTE 2)
R
QJA
26
(NOTE 1)
R
QJC
5.0
¡C/W
Operating junction and storage temperature range T
J
, T
STG
-55 to +150 ¡C
NOTES:
(1) Unit case mounted on Al plate heatsink.
(2) Units mounted on P.C.B. with 0.5 x 0.5" (12 x 12mm) copper pads and 0.375" (9.5mm) lead length
(3) Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
R.
TYP.
TYP.
Dimensions in inches and (millimeters)
Case Style GBU
Polarity shown on front side of case, positive lead beveled corner.
If preferred, marking may be on reverse side of case.
Lead forming option with 7.5mm spacing is available.
2/24/99
NEW PRODUCT NEW PRODUCT NEW PRODUCT
