PI74FCT373T
PI74FCT573T
OCTAL TRANSPARENT LATCHES
3
PS2015B 10/06/04
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ................................................................. –65°C to +150°C
Ambient Temperature with Power Applied ................................. -40°C to +85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) .......... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ....... –0.5V to +7.0V
DC Input Voltage ......................................................................... –0.5V to +7.0V
DC Output Current ................................................................................... 120 mA
Power Dissipation ......................................................................................... 0.5W
Note:
Stresses greater than those listed under MAXI-
MUM RATINGS may cause permanent damage to
the device. This is a stress rating only and functional
operation of the device at these or any other
conditions above those indicated in the operational
sections of this specification is not implied.
Exposure to absolute maximum rating conditions for
extended periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5.0V ± 5%)
Parameters Description Test Conditions
(1)
Min. Typ
(2)
Max. Units
VOH Output HIGH Voltage VCC = Min., VIN = VIH or VIL IOH = –15.0 mA 2.4 3.0 V
VOL Output LOW Current VCC = Min., VIN = VIH or VIL IOL = 64 mA 0.3 0.55 V
VOL Output LOW Current VCC = Min., VIN = VIH or VIL IOL = 12 mA (25Ω Series) 0.3 0.50 V
VIH Input HIGH Voltage Guaranteed Logic HIGH Level 2.0 V
VIL Input LOW Voltage Guaranteed Logic LOW Level 0.8 V
IIH Input HIGH Current VCC = Max. VIN = VCC 1µA
IIL Input LOW Current VCC = Max. VIN = GND –1 µA
IOZH High Impedance VCC = MAX.VOUT = 2.7V 1 µA
IOZL Output Current VOUT = 0.5V –1 µA
VIK Clamp Diode Voltage VCC = Min., IIN = –18 mA –0.7 –1.2 V
IOFF Power Down Disable VCC = GND, VOUT = 4.5V — — 100 µA
IOS Short Circuit Current VCC = Max.
(3)
, VOUT = GND –60 –120 mA
VH Input Hysteresis 200 mV
Capacitance (TA = 25°C, f = 1 MHz)
Parameters
(4)
Description Test Conditions Typ Max. Units
CIN Input Capacitance VIN = 0V 6 10 pF
COUT Output Capacitance VOUT = 0V 8 12 pF
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 5.0V, +25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. This parameter is determined by device characterization but is not production tested.
