Specifications GAL16V8D
10
VIL Input Low Voltage Vss – 0.5 — 0.8 V
VIH Input High Voltage 2.0 — Vcc+1 V
IIL
1
Input or I/O Low Leakage Current 0V ≤ VIN ≤ VIL (MAX.) — — –100 µA
IIH Input or I/O High Leakage Current 3.5V ≤ VIN ≤ VCC ——10µA
VOL Output Low Voltage IOL = MAX. Vin = VIL or VIH — — 0.5 V
VOH Output High Voltage IOH = MAX. Vin = VIL or VIH 2.4 — — V
IOL Low Level Output Current L-3/-5 & -7 (Ind. PLCC) — — 16 mA
L-7 (Except Ind. PLCC)/-10/-15/-25 — — 24 mA
Q-10/-15/-20/-25
IOH High Level Output Current — — –3.2 mA
IOS
2
Output Short Circuit Current VCC = 5V VOUT = 0.5V T
A
= 25°C –30 — –150 mA
Recommended Operating Conditions
Commercial Devices:
Ambient Temperature (T
A
) ............................... 0 to 75°C
Supply voltage (V
CC
)
with Respect to Ground ..................... +4.75 to +5.25V
Industrial Devices:
Ambient Temperature (T
A
) ........................... –40 to 85°C
Supply voltage (V
CC
)
with Respect to Ground ..................... +4.50 to +5.50V
Absolute Maximum Ratings
(1)
Supply voltage V
CC
...................................... –0.5 to +7V
Input voltage applied .......................... –2.5 to V
CC
+1.0V
Off-state output voltage applied ......... –2.5 to V
CC
+1.0V
Storage Temperature ................................ –65 to 150°C
Ambient Temperature with
Power Applied ........................................ –55 to 125°C
1.Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device at
these or at any other conditions above those indicated in the
operational sections of this specification is not implied (while
programming, follow the programming specifications).
DC Electrical Characteristics
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL PARAMETER CONDITION MIN. TYP.
3
MAX. UNITS
COMMERCIAL
ICC Operating Power VIL = 0.5V VIH = 3.0V L -3/-5/-7/-10 — 75 115 mA
Supply Current f
toggle = 15MHz Outputs Open L-15/-25 — 75 90 mA
Q-10/-15/-25 — 45 55 mA
INDUSTRIAL
ICC Operating Power VIL = 0.5V VIH = 3.0V L -7/-10/-15/-25 — 75 130 mA
Supply Current f
toggle = 15MHz Outputs Open Q -20/-25 — 45 65 mA
1) The leakage current is due to the internal pull-up resistor on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Characterized but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C
