ADS804
2
SBAS068B
www.ti.com
+V
S
, VDRV ........................................................................................... +6V
Analog Input .......................................................... (–0.3V) to (+V
S
+ 0.3V)
Logic Input ............................................................ (–0.3V) to (+V
S
+ 0.3V)
Case Temperature ......................................................................... +100°C
Junction Temperature .................................................................... +150°C
Storage Temperature ..................................................................... +150°C
NOTE: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may degrade
device reliability.
ABSOLUTE MAXIMUM RATINGS
(1)
ADS804E
PARAMETER CONDITIONS MIN TYP MAX UNITS
RESOLUTION 12 Bits
SPECIFIED TEMPERATURE RANGE –40 to +85 °C
CONVERSION CHARACTERISTICS
Sample Rate 10k 10M Samples/s
Data Latency 6 Clk Cycles
ANALOG INPUT
Single-Ended Input Range 1.5 3.5 V
Single-Ended Input Range (Optional) 0 5 V
Common-Mode Voltage +2.5 V
Input Impedance 1.25 || 16 MΩ || pF
Track-Mode Input Bandwidth –3dBFS Input 270 MHz
DYNAMIC CHARACTERISTICS
Differential Linearity Error (Largest Code Error)
f = 500kHz ±0.3 ±0.75 LSB
No Missing Codes Tested
Spurious-Free Dynamic Range
(1)
f = 4.8MHz 73 80 dBFS
2-Tone Intermodulation Distortion
(3)
f = 3.5MHz and 4.0MHz (–7dBFS each tone) 76 dBc
Signal-to-Noise Ratio (SNR)
f = 4.8MHz 66.5 69 dBFS
Signal-to-(Noise + Distortion) (SINAD)
f = 4.8MHz 65 68 dBFS
Effective Number of Bits at 4.8MHz
(4)
11 Bits
Input Referred Noise 0V to 5V Input 0.09 LSBs rms
1.5V to 3.5V Input 0.23 LSBs rms
Integral Nonlinearity Error
f = 500kHz ±1 ±2 LSB
Aperture Delay Time 1ns
Aperture Jitter 4 ps rms
Over-Voltage Recovery Time 1.5 • FS Input 2 ns
Full-Scale Step Acquisition Time 30 ns
ELECTRICAL CHARACTERISTICS
At T
A
= full specified temperature range, V
S
= +5V, specified input range = 1.5V to 3.5V, single-ended input, and sampling rate = 5MHz, unless otherwise specified.
SPECIFIED
PACKAGE TEMPERATURE PACKAGE ORDERING TRANSPORT
PRODUCT PACKAGE-LEAD DESIGNATOR
(1)
RANGE MARKING NUMBER MEDIA, QUANTITY
ADS804 SSOP-28 DB –40°C to +85°C ADS804E ADS804E Rails, 48
"" " ""ADS804E/1K Tape and Reel, 1000
NOTE: (1) For the most current specifications and package information, refer to our web site at www.ti.com.
PACKAGE/ORDERING INFORMATION
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas Instru-
ments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may be
more susceptible to damage because very small parametric
changes could cause the device not to meet its published
specifications.