Output Options:
Standard Stability Options:
Stability vs Supply:
B-307 = ±3.0 x 10
-7
over 0ºC to +50ºC
B-ST3 = Stratum 3 over 0ºC to +50ºC
C-ST3 = Stratum 3 over 0ºC to +70ºC
C-507 = ±5.0 x 10
-7
over 0ºC to +70ºC
F-106 = ±1.0 x 10
-6
over -40ºC to +85ºC
STRATUM 3 per GR-1244-CORE Table 3-1
Total Stability: <±4.6 x 10
-6
for all causes & 10 years
Vs Holdover: <±3.7 x 10
-7
for all causes and 24 Hours
(Available in Temperature Ranges B & C)
Current Draw:
Current draw will vary greatly depending on frequency and output type.
For this series TCXO typical current draw will be about 15 mA and
depending on output type may be less than 2 mA. Please consult the
factory about your exact current requirements.
Supply Voltage (Vdd):
(Other options are available upon request)
C = 5 Vdc ±5%
D = 3.3 Vdc ±5%
Electrical Frequency
Adjust:
±5 ppm minimum
via external voltage, 0 to Vdd
Phase Noise (Typical):
10 MHz
Offset
Phase Noise
100 Hz -115 dBc/Hz
1k Hz -145 dBc/Hz
10k Hz -150 dBc/Hz
100k Hz -155 dBc/Hz
Aging (typical):
<3.5 ppm for ten years @ +70ºC
<±0.1 ppm for a ±5% change in Supply Voltage
Package:
210 = 29.21 x 25.40 x 10.03 mm (1.15 x 1.00 x 0.395) (See page 3)
A = HCMOS / ACMOS 0.5 to 160 MHz
B = 10 TTL 0.5 to 160 MHz
F = Complementary PECL 35 to 160 MHz
G = 0 dBm / 50 ohm 5.0 to 100 MHz
Note: Other stability options are available.
Contact the factory for assistance.
For HCMOS / ACMOS / TTL & PECL
outputs with frequencies above 35 MHz
a low phase noise PLL multiplier may be
used. Please inform that factory of your
phase noise requirements.
Standard Frequencies:
10.00, 12.80, 16.384, 19.44, 20.00, 38.88, 40.00, 77.76, 155.52 MHz,
Available from 0.5 MHz to 160 MHz
*
*
*
Vectron International 267 Lowell Road, Hudson, NH 03051
