Freelance Electronics Components Distributor
Closed Dec 25th-26th
800-300-1968
We Stock Hard to Find Parts

GRM32DR71C106KA01L

Part # GRM32DR71C106KA01L
Description CAP 10UF 16VDC X7R 10% SMD 1210 - Tape and Reel
Additional Information:


Category CAPACITOR
Availability Out of Stock
Qty 0
Qty Price
1 + $0.05362



Technical Document


DISCLAIMER: The information provided herein is solely for informational purposes. Customers must be aware of the suitability of this product for their application, and consider that variable factors such as Manufacturer, Product Category, Date Codes, Pictures and Descriptions may differ from available inventory.

2010-2012 Microchip Technology Inc. DS39977F-page 1
Power-Managed Modes:
Run: CPU on, Peripherals on
Idle: CPU off, Peripherals on
Sleep: CPU off, Peripherals off
Two-Speed Oscillator Start-up
Fail-Safe Clock Monitor (FSCM)
Power-Saving Peripheral Module Disable (PMD)
Ultra Low-Power Wake-up
Fast Wake-up, 1 s, Typical
Low-Power WDT, 300 nA, Typical
Run mode Currents Down to Very Low 3.8 A, Typical
Idle mode Currents Down to Very Low 880 nA, Typical
Sleep mode Current Down to Very Low 13 nA, Typical
ECAN Bus Module Features:
Conforms to CAN 2.0B Active Specification
Three Operating modes:
- Legacy mode (full backward compatibility with
existing PIC18CXX8/FXX8 CAN modules)
- Enhanced mode
- FIFO mode or programmable TX/RX buffers
Message Bit Rates up to 1 Mbps
DeviceNet™ Data Byte Filter Support
Six Programmable Receive/Transmit Buffers
Three Dedicated Transmit Buffers with Prioritization
Two Dedicated Receive Buffers
ECAN Bus Module Features (Continued):
16 Full, 29-Bit Acceptance Filters with Dynamic
Association
Three Full, 29-Bit Acceptance Masks
Automatic Remote Frame Handling
Advanced Error Management Features
Special Microcontroller Features:
Operating Voltage Range: 1.8V to 5.5V
On-Chip 3.3V Regulator
Operating Speed up to 64 MHz
Up to 64 Kbytes On-Chip Flash Program Memory:
- 10,000 erase/write cycle, typical
- 20 years minimum retention, typical
1,024 Bytes of Data EEPROM:
- 100,000 Erase/write cycle data EEPROM
memory, typical
3.6 Kbytes of General Purpose Registers (SRAM)
Three Internal Oscillators: LF-INTOSC (31 KHz),
MF-INTOSC (500 kHz) and HF-INTOSC (16 MHz)
Self-Programmable under Software Control
Priority Levels for Interrupts
8 x 8 Single-Cycle Hardware Multiplier
Extended Watchdog Timer (WDT):
- Programmable period from 4 ms to 4,194s
In-Circuit Serial Programming™ (ICSP™) via Two Pins
In-Circuit Debug via Two Pins
Programmable BOR
Programmable LVD
TABLE 1: DEVICE COMPARISON
Device
Program
Memory
Data
Memory
(Bytes)
Data EE
(Bytes)
Pins I/O
CTMU
12-Bit A/D
Channels
CCP/
ECCP
Timers
8-Bit/16-Bit
EUSART
Comparators
ECAN™
MSSP
BORMV/LVD
DSM
PIC18F25K80 32 Kbytes 3,648 1,024 28 24 1 8-ch 4/1 2/3 2 2 1 1 Yes No
PIC18LF25K80 32 Kbytes 3,648 1,024 28 24 1 8-ch 4/1 2/3 2 2 1 1 Yes No
PIC18F26K80 64 Kbytes 3,648 1,024 28 24 1 8-ch 4/1 2/3 2 2 1 1 Yes No
PIC18LF26K80 64 Kbytes 3,648 1,024 28 24 1 8-ch 4/1 2/3 2 2 1 1 Yes No
PIC18F45K80 32 Kbytes 3,648 1,024 40/44 35 1 11-ch 4/1 2/3 2 2 1 1 Yes No
PIC18LF45K80 32 Kbytes 3,648 1,024 40/44 35 1 11-ch 4/1 2/3 2 2 1 1 Yes No
PIC18F46K80 64 Kbytes 3,648 1,024 40/44 35 1 11-ch 4/1 2/3 2 2 1 1 Yes No
PIC18LF46K80 64 Kbytes 3,648 1,024 40/44 35 1 11-ch 4/1 2/3 2 2 1 1 Yes No
PIC18F65K80 32 Kbytes 3,648 1,024 64 54 1 11-ch 4/1 2/3 2 2 1 1 Yes Yes
PIC18LF65K80 32 Kbytes 3,648 1,024 64 54 1 11-ch 4/1 2/3 2 2 1 1 Yes Yes
PIC18F66K80 64 Kbytes 3,648 1,024 64 54 1 11-ch 4/1 2/3 2 2 1 1 Yes Yes
PIC18LF66K80 64 Kbytes 3,648 1,024 64 54 1 11-ch 4/1 2/3 2 2 1 1 Yes Yes
PIC18F66K80 FAMILY
28/40/44/64-Pin, Enhanced Flash Microcontrollers
with ECAN™ and nanoWatt XLP Technology
PIC18F66K80 FAMILY
DS39977F-page 2 2010-2012 Microchip Technology Inc.
Peripheral Highlights:
Five CCP/ECCP modules:
- Four Capture/Compare/PWM (CCP) modules
- One Enhanced Capture/Compare/PWM
(ECCP) module
Five 8/16-Bit Timer/Counter modules:
- Timer0: 8/16-bit timer/counter with 8-bit
programmable prescaler
- Timer1, Timer3: 16-bit timer/counter
- Timer2, Timer4: 8-bit timer/counter
Two Analog Comparators
Configurable Reference Clock Output
Charge Time Measurement Unit (CTMU):
- Capacitance measurement
- Time measurement with 1 ns typical resolution
- Integrated voltage reference
High-Current Sink/Source 25 mA/25 mA
(PORTB and PORTC)
Up to Four External Interrupts
One Master Synchronous Serial Port
(MSSP) module:
- 3/4-wire SPI (supports all four SPI modes)
-I
2
C™ Master and Slave modes
Two Enhanced Addressable USART modules:
- LIN/J2602 support
- Auto-Baud Detect (ABD)
12-Bit A/D Converter with up to 11 Channels:
- Auto-acquisition and Sleep operation
- Differential Input mode of operation
Data Signal Modulator module:
- Select modulator and carrier sources from
various module outputs
Integrated Voltage Reference
2010-2012 Microchip Technology Inc. DS39977F-page 3
PIC18F66K80 FAMILY
Pin Diagrams
RA1/AN1
RB3/CANRX/C2OUT/P1D/CTED2/INT3
RA2/V
REF-/AN2
V
DDCORE/VCAP
RA5/AN4/C2INB/HLVDIN/T1CKI/SS/CTMUI
OSC1/CLKIN/RA7
28-Pin QFN
(1)
RA0/CVREF/AN0/ULPWU
MCLR
/RE3
RB7/PGD/T3G/RX2/DT2/KBI3
RC0/SOSCO/SCLKI
RC1/SOSCI
RC2/T1G/CCP2
RC3/REFO/SCL/SCK
RA3/VREF+/AN3
V
SS
OSC2/CLKOUT/RA6
RB2/CANTX/C1OUT/P1C/CTED1/INT2
RB1/AN8/C1INB/P1B/CTDIN/INT1
RB0/AN10/C1INA/FLT0/INT0
V
DD
VSS
RC7/CANRX/RX1/DT1/CCP4
RC4/SDA/SDI
RC5/SDO
RC6/CANTX/TX1/CK1/CCP3
RB6/PGC/TX2/CK2/KBI2
RB5/T0CKI/T3CKI/CCP5/KBI1
RB4/AN9/C2INA/ECCP1/P1A/CTPLS/KBI0
Note 1: For the QFN package, it is recommended that the bottom pad be connected to VSS.
1
2
3
4
7
5
6
21
20
19
18
15
17
16
28
27
26
25
24
23
22
8
9
10
11
12
13
14
PIC18F2XK80
PIC18LF2XK80
1234567NEXT